Hot Water Perth Plumber

Hot water perth is an important aspect of your home, and selecting the right hot water system will ensure that your needs are met in the most efficient way. There are some considerations that you need to make when deciding on the hot water system to use in your home. It is a good idea to consider the number of people that are in your household, the way hot water is used in your home and the energy source that you will use to heat the water. You should get an expert to do your hot water plumbing to ensure that the system is properly fixed and functional.

Solar Hot Water System

A solar hot water system is normally installed on the roof of your home. The system is made up of solar collectors which trap energy from the sun which is used to heat the water. The heated water then flows into a storage tank. If you live in an area with plenty of sunshine, you are likely to have up to ninety percent of your hot water from solar. This can enable you to make significant energy savings, and your bills will go down.

Solar hot water systems are known to be more costly when purchasing and installing than other hot water systems. However, they last longer, add value to your home and are cheaper in the long term once you have recovered the initial cost of the system from the savings you make.

There are days when you will experience cold weather and solar hot water systems usually come with gas or electric boosters. The boosters heat the water when the hot water supply is not enough for your needs.

Continuous Flow Water Heater

A continuous flow water system works by heating up the water that is required at that particular time. This means that there is no need for storage tanks since the water is used there and then. This is an energy efficient system since there is no loss of energy or heat. The continuous flow hot water system can use electricity, LPG or natural gas to heat the water. The heater can have controls which allow you set the temperature of your choice, which means the risks of burns are reduced.

Heat Pump Water Heater

The air sourced heat pumps absorb heat from the surroundings and use this heat to warm up the water. The system works by using air from the environment to heat a liquid refrigerant. The refrigerant turns into a gas and is compressed which causes heat to be released. The heat warms up the water and the refrigerant expands, causing it to convert back into a liquid. The cycle continues, and this causes the water to be heated up.

The water that is to be heated comes into the cylinder through an inlet and goes to the bottom of the cylinder while the warmer water is at the top. A compressor which is powered by electricity sucks in warm air which comes in through a vent. An exhaust fan enables the warm air to come in and the cold air to be ejected from the motor. The warm refrigerant moves from the compressor around the cylinder, while the cool refrigerant goes back to the evaporator.